WIRELESS AND SWITCHING

HPE Aruba Installation and Consulting

We install HPE Aruba Networking (formerly Aruba) switches and access points, configure them with Aruba Central or local management, and tidy up existing Aruba networks. Wireless coverage and channel planning and switch-side VLANs, uplinks and PoE are handled in the same project.

Aruba CX and Instant On

Wireless coverage planning and switch configuration in one project.

SCOPE OF SERVICE

What do we cover on your Aruba network?

We start by documenting existing devices, software versions, licences and access point placement against the floor plan.

01

Aruba CX switches

VLANs, LAG, STP and inter-VLAN routing on AOS-CX based CX series switches; a redundant core with VSX where needed.

02

Instant On

For small offices, Instant On switches and access points set up from the mobile app or web portal, with guest network and network separation.

03

Wireless network

Access point placement, channel and power settings, WPA3 or 802.1X on corporate networks, guest network and roaming settings.

04

Central management

Templates, firmware and monitoring with HPE Aruba Networking Central; licence term tracking.

05

Authentication

802.1X and MAC-based access control with ClearPass or your existing RADIUS server (for example Windows NPS).

COMMON SITUATIONS

What we see most often on Aruba networks

01

Wi-Fi drops

Channel overlap, excessive transmit power and wrong roaming settings are identified through measurement and corrected.

02

Coverage gaps

Access point placement is replanned using the floor plan and measurement results.

03

Moving from older switches to CX

When moving from older ArubaOS-Switch models to the CX series, the configuration is converted to the new syntax.

04

Expiring licences

Central and device licence terms are reported; renewal or a change of management model is planned.

PROJECT PHASES

How does the project proceed?

01 / STAGE

Inventory and measurement

Devices, versions, licences and current wireless performance are recorded.

02 / STAGE

Design

Access point placement, SSID and VLAN plan, switch uplinks and PoE design are prepared.

03 / STAGE

Implementation

Devices are preconfigured; installation and cutover follow a plan.

04 / STAGE

Validation and handover

Coverage and roaming tests are carried out; configuration and documentation are handed over.

DELIVERABLES

What do you receive at handover?

Access point placement plan, SSID and VLAN table, switch configuration backups, port map, wireless test results, licence status and maintenance recommendations.

FREQUENTLY ASKED QUESTIONS

Let’s clarify a detail

01

Instant On or Aruba Central?

For small offices with a few access points and switches, Instant On may be enough. If you need multiple locations, 802.1X and detailed monitoring, Central-managed products are a better fit.

02

Do you measure coverage?

We plan coverage from the floor plan and verify it with measurements after installation.

03

Can we use Aruba with other vendors’ switches?

Yes. VLAN, LACP and STP work over standard protocols; STP mode and root bridge placement are defined up front.

04

Are you an HPE Aruba partner?

This page is not a statement of partnership or authorised service. Where vendor support is needed, we work with HPE under your own support contract.

ERETEK NETWORK

Let’s plan your Aruba network together

Share your floor plan, user count and existing devices; we will work out access point placement and the task list.