Network and IP Planning · #12

Online Uplink Oversubscription Calculator

Calculates the ratio of total downlink to uplink capacity normally and after losing one uplink.

  • Data is processed in your browser and not sent to a server

Tool

Gbps per port (100 Mbps = 0.1).

E.g. mGig or 10G access ports.

LAG/port-channel members or separate uplinks.

Gbps per uplink.

Enter 3 to flag anything above 3:1.

What does this tool do?

Oversubscription is unavoidable on edge switches and usually acceptable, because end devices do not all talk at full speed at once. The problem is that losing one uplink doubles the ratio, and the plan rarely shows it. The tool shows both cases side by side and reminds you that a LAG does not raise the speed of a single flow.

How to use it

  1. Enter the number and speed of downlink ports; add a second group if some ports run at a different speed.
  2. Enter the number of uplinks and the speed per uplink.
  3. Optionally enter a target ratio (e.g. 3 → 3:1); values above it are flagged.

Fields

Downlink ports
Downlink speed
Gbps per port (100 Mbps = 0.1).
Group 2 ports (optional)
E.g. mGig or 10G access ports.
Group 2 speed
Uplinks
LAG/port-channel members or separate uplinks.
Uplink speed
Gbps per uplink.
Target ratio (optional)
Enter 3 to flag anything above 3:1.

Worked example

InputValue
Downlink ports24
Downlink speed1
Uplinks2
Uplink speed10

Expected result: 24 × 1 Gbps = 24 Gbps downlink, 2 × 10 Gbps = 20 Gbps uplink → 1.2:1; 2.4:1 after losing one uplink.

This switch is almost non-blocking normally but reaches 2.4:1 on a single uplink. That is usually fine in an office access layer; with heavy file transfers or video recording, decide on the N-1 ratio.

Second scenario

InputValue
Downlink ports44
Downlink speed2.5
Group 2 ports (optional)4
Group 2 speed10
Uplinks2
Uplink speed25
Target ratio (optional)3

Expected result: 44 × 2.5 + 4 × 10 = 150 Gbps; 2 × 25 = 50 Gbps → 3:1, and 6:1 in the N-1 case (the 3:1 target is exceeded).

Method and assumptions

Ratio = Σ(downlink ports × speed) / (uplinks × uplink speed). For N-1 the denominator is (uplinks − 1) × speed. With a single uplink N-1 is undefined (∞).

A LAG raises total capacity, but hashing means a single flow cannot exceed the speed of one member.

Using the result and troubleshooting

Campus access layers commonly run up to 20:1, distribution around 4:1; data centre and storage traffic aims for 1:1–3:1. Verify with your own traffic measurements.

For constant traffic such as camera recording, add up the real load instead of using a ratio: the CCTV Bandwidth Calculator gives that total.

Limits and common mistakes

  • It does not know your traffic profile; it gives the worst case with all ports at full speed.
  • Stacking links and internal fabric capacity are not considered.

Frequently asked questions

Is 1.2:1 good?

A ratio alone is neither good nor bad; it depends on how many devices transmit at once. The point to watch here is that the ratio doubles in the N-1 case.

Related tools and service

Related service: Enterprise Network Consulting

Network online tools · See all online tools